Hello friends,

I tested it to see if I could use it as a wood burning machine, which I made to use DC motors as a cyclic machine. In conclusion; I found that extremely high heat was generated in the parts due to the high amperage of the transformer I used and the poor quality of the cables and sockets. I evaluated that if you are only going to drive a DC motor, the device is sufficient, but if you are going to burn wood, you should buy a transformer with a lower amperage. If you buy the cables and sockets you will use in the project from heat-resistant quality materials, you can also burn wood.

I hope it gives you an idea too.

Enjoy watching.

WARNING: The actions in this video are life-threatening. If you have no electrical knowledge, please do not try what is done here.

Materials:

12V – 10A Led Transformer

12V – 10A DC Motor Dimmer

ON-OFF Switch

12V Fan

Cables and Sockets